Mitsubishi Electric Q12DCCPU-V - Removing a Battery before Storage

6
PREPARATORY PROCEDURES AND SETTING
6.7 Specifications, Installation, and Replacement of the Battery
6.7.5 Removing a battery before storage
6 - 57
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK MODULES
6
PREPARATORY PROCEDURES AND SETTING
7
I/O NUMBER ASSIGNMENT
8
MEMORIES AND FILES
6.7.5 Removing a battery before storage
To store the C Controller module with a battery removed, perform the shutdown operation,
power off the C Controller system, and then remove the battery.
[Operating procedure]
1) Mount the C Controller module on the base unit and power it on.
2) Perform the shutdown operation ( (1) in this section), and power off the C
Controller system.
3) Remove the battery from the C Controller module.
IMPORTANT
Data in the standard RAM, standard ROM being accessed, or battery-backed-up RAM
may be corrupted or a file system error may occur if the procedure given below is not
followed.
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B