Mitsubishi Electric Q12DCCPU-V - Peripheral Devices that Can be Connected

4 - 53
4.16 Functions for Communicating with Peripheral Devices through an Ethernet Port
4
FUNCTIONS
4.16 Functions for Communicating with Peripheral Devices through
an Ethernet Port
Implement communications by connecting a peripheral device (such as GX Developer) to
the Ethernet port on the C Controller module with an Ethernet cable.
Functions for communicating with a peripheral device through an Ethernet port cannot be
used with the following C Controller modules.
• Q12DCCPU-V with a serial number whose first five digits are "12041" or higher
(1) Peripheral devices that can be connected
The following peripheral devices can be connected to the Ethernet port of the C
Controller module.
• GX Works2/GX Developer
For connection methods, refer to the following.
Page App-25, Appendix 9
• MT Works2
For connection methods, refer to the following.
User's manual for the Motion CPU module
• MX Component
For connection methods, refer to the following.
Page App-37, Appendix 10
• GOT
For connection methods, refer to the following.
GOT1000 Series Connection Manual (Mitsubishi Products)
Figure 4.24 Example of the connection with a peripheral device through an Ethernet port
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
Ethernet
Hub
C Controller module
GX Developer GOT