5 - 14
5.3 MELSECNET/H Module Access Function
5.3.1 Message communication
5
ACCESS VIA NETWORK MODULES
Pay attention to the following when sending a message to a MELSECNET/H
module controlled by a programmable controller CPU.
When sending data twice to the same channel of the receiving station with ACK
set, execute the second transmission after the receiving station has read out the
first data by the RECV instruction.
Failure to do so will cause an error. If an error is detected, retry the transmission
after a little while.
ret = QBF_SEND();
ret = QBF_SEND();
RECV
C Controller module
(Sending station)
User program
MELSECNET/H module
Channel 3
Error
Logical channel
(Channel 5)
Network module
CPU (Receiving
station)
To Next Page
Loading...
