6 - 30
6.4 Part Names and Functions
6.4.1 Part names and functions of the Q12DCCPU-V
6
PREPARATORY PROCEDURES AND SETTING
* 2 In a multiple CPU system configuration, reset CPU No.1.
( Page 12-21, Section 12.6)
* 3 Data corruption or file system failure may occur if the C Controller system is reset during writing of
a user file in the standard RAM or CompactFlash card.
If a user file in the standard RAM or CompactFlash card is being written, perform the operation
shown in the following before resetting the module.
( Page 8-9, Section 8.2.2 (2))
* 4 When the SELECT position is held in either of the following conditions, the CompactFlash card is
not unmounted. (The CF CARD LED does not flash.)
• No CompactFlash card is installed.
• The CompactFlash card has already been unmounted.
To Next Page
Loading...
