Mitsubishi Electric Q12DCCPU-V - Page 340

7 - 27
7.7 I/O Assignment Example
7
I/O NUMBER ASSIGNMENT
(b) I/O assignment setting in C Controller setting utility
In the <<I/O assignment settings>> tab of C Controller setting utility, set "200" for
Slot No.3 and "70" for Slot No.4.
(c) I/O number assignment after change
Figure 7.23 I/O assignment setting (when changing the I/O number of Slot 3)
Figure 7.24 I/O number assignment (after change of the I/O number for the slot)
Set "200" for the start
I/O number.
Set "70" for the start
I/O number. (No entry
will assign the I/O
number next to those
of Slot 3.)
Extension 1
to toto
to to to toto
to toto
to to to toto
Q38B
Q68B
012 45673
X00 X20 X40 Y70 Y90 YB0 YD0X200
X1F X3F X5F Y8F YAF YCF YEFX21F
8 9 10 12 13 14 1511
F0 110 130 170 Y180 Y1A0 Y1C0150
10F 12F 14F 17F Y19F Y1BF Y1DF16F
Input module Input module Input module Input module
Output module Output module Output module Output module
32
points
32
points
32
points
32
points
32
points
32
points
32
points
32
points
Number of
I/O points
Slot number
I/O number
Intelligent function module Intelligent function module Intelligent function module Intelligent function module
Empty
Output module Output module Output module
32
points
32
points
32
points
16
points
32
points
32
points
32
points
32
points