Mitsubishi Electric Q12DCCPU-V - Page 361

11
MULTIPLE CPU SYSTEM CONFIGURATION
11.1 System Configuration
11.1.1 Devices used for each base unit
11 - 2
9
DEVICE DESCRIPTION
10
MULTIPLE CPU SYSTEM OVERVIEW
11
MULTIPLE CPU SYSTEM CONFIGURATION
12
CONCEPT OF MULTIPLE CPU SYSTEM
13
COMMUNICATIONS BETWEEN CPU MODULES
14
PARAMETERS ADDED FOR MULTIPLE CPU SYSTEMS
15
STARTING A MULTIPLE CPU SYSTEM
16
TROUBLESHOOTING
11.1.1 Devices used for each base unit
(1) When using the main base unit (Q3 B)
* 1 The Q12DCCPU-V and a Motion CPU cannot be installed on the same base unit.
* 2 To a Motion CPU, a CompactFlash card and a battery cannot be installed.
* 3 Use a Q series power supply module.
The current consumption must be the rated output current or less.
Slim type power supply modules and redundant power supply modules cannot be used.
* 4 No power supply module is required for the Q5 B extension base unit.
* 5 The control CPU of a Motion module must be a Motion CPU.
* 6 For the Q06CCPU-V-B, CompactFlash cards cannot be used.
* 7 For the Q06CCPU-V(-B), the Q7BAT cannot be used.
POINT
1. For combinations of configurable CPU modules, refer to the following.
Page 12-1, Section 12.1
2. When a C Controller module is used in a multiple CPU system, any redundant
power base units cannot be used.
Figure 11.1 When a main base unit is used
CompactFlash card
(sold separately)
*6
Q3 B type main base unit
*3
Q series power supply module, I/O module,
intelligent function module, Motion module
*5
Q5 B type extension base unit
*4
Q6 B type extension base unit
*3
Extension cable
Motion CPU
*2
C Controller
module
*1
Battery
*7