11
MULTIPLE CPU SYSTEM CONFIGURATION
11.1 System Configuration
11.1.1 Devices used for each base unit
11 - 4
9
DEVICE DESCRIPTION
10
MULTIPLE CPU SYSTEM
OVERVIEW
11
MULTIPLE CPU SYSTEM
CONFIGURATION
12
CONCEPT OF MULTIPLE
CPU SYSTEM
13
COMMUNICATIONS
BETWEEN CPU
MODULES
14
PARAMETERS ADDED
FOR MULTIPLE CPU
SYSTEMS
15
STARTING A MULTIPLE
CPU SYSTEM
16
TROUBLESHOOTING
(3) When using the multiple CPU high speed main base unit (Q3 DB)
* 1 The Q12DCCPU-V and a Motion CPU (except the Q172DCPU and Q173DCPU) cannot be
installed on the same base unit.
* 2 To a Motion CPU, a CompactFlash card and a battery cannot be installed.
* 3 Use a Q series power supply module.
The current consumption must be the rated output current or less.
Slim type power supply modules and redundant power supply modules cannot be used.
* 4 No power supply module is required for the Q5 B extension base unit.
* 5 The control CPU of a Motion module must be a Motion CPU.
* 6 For the Q06CCPU-V-B, CompactFlash cards cannot be used.
* 7 For the Q06CCPU-V(-B), the Q7BAT cannot be used.
For combinations of configurable CPU modules, refer to the following.
Page 12-1, Section 12.1
Figure 11.3 When a multiple CPU high speed main base unit is used
CompactFlash card
(sold separately)
*6
Battery
*7
Motion
CPU
*2
C Controller module
*1
Extension cable
Q series power supply module, I/O module,
intelligent function module, Motion module
*5
Q3 DB multiple CPU high speed main base unit
*3
Q5 B extension base unit
*4
Q6 B extension base unit
*3
To Next Page
Loading...
