1
OVERVIEW
1 - 3
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK
MODULES
6
PREPARATORY
PROCEDURES AND
SETTING
7
I/O NUMBER
ASSIGNMENT
8
MEMORIES AND FILES
This manual mainly describes the C Controller module itself.
For the C Controller system information listed below, refer to the following.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)
When reading the above manual, interpret the terms, "CPU module" and
"programmable controller" as "C Controller module" and "C Controller system"
accordingly.
Table 1.2 List of referenced sections
Item Refer to
Checking the power supply module specifications to make a
selection
Chapter 5
Checking the specifications of base units and extension cables to
make a selection, and configuring the system
Chapter 6
Compliance of the C Controller system with the EMC and Low
Voltage Directives
Chapter 9
Calculating the heat value of the C Controller system Section 10.2
Mounting modules Section 10.3
Checking how to set the number of extension base units Section 10.4
Connecting/disconnecting extension cables Section 10.5
Wiring the power supply module Section 10.6
Checking I/O module troubleshooting cases Section 12.5
Checking external dimensions of power supply modules and base
units
Appendix 1
To Next Page
Loading...
