Mitsubishi Electric Q12DCCPU-V - Page 467

15
STARTING A MULTIPLE CPU SYSTEM
15.2 Setting Parameters Added for Multiple CPU Systems
15.2.3 When creating a new system
15 - 13
9
DEVICE DESCRIPTION
10
MULTIPLE CPU SYSTEM OVERVIEW
11
MULTIPLE CPU SYSTEM CONFIGURATION
12
CONCEPT OF MULTIPLE CPU SYSTEM
13
COMMUNICATIONS BETWEEN CPU MODULES
14
PARAMETERS ADDED FOR MULTIPLE CPU SYSTEMS
15
STARTING A MULTIPLE CPU SYSTEM
16
TROUBLESHOOTING
Remark
For C Controller setting utility, refer to the following.
C Controller Module User's Manual (Utility Operation, Programming)
Figure 15.6 Parameter setting procedure for creating a new multiple CPU system
In the Type column in the <<I/O
assignment>> tab, select "CPU (Empty)"
for a slot where no module is mounted.
Click the Detailed settings button to
open the Detailed settings screen.
(From the previous page)
Set parameters other than these
multiple CPU system parameters.
Save the set parameters into a file.
End
Control CPU (setting required)
Select a control CPU (No.1 to No.4) for
each slot.
The setting is not available for
intelligent function modules of function
version A.