Mitsubishi Electric Q12DCCPU-V - Page 470

15 - 16
15.2 Setting Parameters Added for Multiple CPU Systems
15.2.4 Importing existing multiple CPU parameters
15
STARTING A MULTIPLE CPU SYSTEM
Remark
For C Controller setting utility, refer to the following.
C Controller Module User's Manual (Utility Operation, Programming)
Figure 15.7 Parameter setting procedure for importing multiple CPU system parameters
(From previous page)
Check the "Points occupied by empty slot"
setting on the <<System settings>> tab.
Set parameters other than these multiple
CPU system parameters.
Save the set parameters into a file.
End