16
TROUBLESHOOTING
16.2 Troubleshooting
16.2.14 When an error occurred during user program download or ld command execution
16 - 26
9
DEVICE DESCRIPTION
10
MULTIPLE CPU SYSTEM
OVERVIEW
11
MULTIPLE CPU SYSTEM
CONFIGURATION
12
CONCEPT OF MULTIPLE
CPU SYSTEM
13
COMMUNICATIONS
BETWEEN CPU
MODULES
14
PARAMETERS ADDED
FOR MULTIPLE CPU
SYSTEMS
15
STARTING A MULTIPLE
CPU SYSTEM
16
TROUBLESHOOTING
(b) For the Q06CCPU-V(-B)
1) When downloading a user program to a C Controller module
2) When executing a user program with the ld command
(2) Corrective actions
1) Check the endian format of the user program.
For the checking method, refer to the following.
C Controller Module User's Manual (Utility Operation, Programming)
2) If the endian format of the user program is different from that of the C
Controller module, recompile the user program so that the same endian format
will be used.
Error: This is not an elf module for the SH architecture.
Error: Object module load failed for C:/xxx/Demo1.out
Removed Demo1.out from target..........done
WTX Error 0x1002e (LOADER_UNKNOWN_OBJ_MODULE_FORMAT)
Figure 16.16 Error message
ld(1,0,"/ROM/Demo1.out")
Incorrect ELF header size: 13312
ld error: error reading file (errno = 0x3d0001).
value = 0 = 0x0
Figure 16.17 Error message
To Next Page
Loading...
