16 - 89
16.5 Hardware Self-Diagnostic Function
16.5.2 Hardware self-diagnostic test and initialization setting of the Q06CCPU-V(-B)
16
TROUBLESHOOTING
(5) Confirming the hardware self-diagnostic test and initialization setting
result
(a) Normal completion
1) The flashing LED turns off during the diagnostics and setting.
2) Turn the power off to finish the hardware self-diagnostic mode.
Standard ROM format setting (formatting of the standard ROM) takes effect next
time the C Controller module is started after the setting.
When the setting is completed normally, the RUN and USER LEDs are turned off
and the MODE LED starts flashing green.
Figure 16.29 LED indication for normal completion (for the Q06CCPU-V)
On
RUN
CF CARD
CH2 SD/RD
MODE
ERR.
USER
To Next Page
Loading...
