Mitsubishi Electric Q12DCCPU-V - Page 587

APPENDICES
Appendix 8 Parameter Number List
APPX - 23
A
I
(2) Parameter No. list
The following table shows the parameter numbers and where each of them is to be
set.
(To the next page)
Table APPX.25 Parameter No. list
Parameter No. Item Utility
0400H I/O assignment
Type
C Controller setting utility
Model name
Points
Start X/Y (Start I/O No.)
0401H Base setting
Base model
C Controller setting utility
Power model
Extension cable
Slots
0403H
Detailed setting
Error time output mode C Controller setting utility
0405H I/O response time C Controller setting utility
0406H Control CPU C Controller setting utility
0407H Switch settings C Controller setting utility
0409H Switch settings C Controller setting utility
05mnH Group No. MELSECNET/H utility
0AmnH Group No. CC IE Control utility
0CmnH Operation setting
Type
CC-Link utility
Mode setting
Extended cyclic settings
Number of occupied stations
Input data at error time
Setting during CPU STOP
0E00H Number of CPUs C Controller setting utility
0E01H Operation mode C Controller setting utility
0E04H
I/O sharing when using Multiple
CPUs
All CPUs can read all inputs
C Controller setting utility
All CPUs can read all outputs
1002H Remote reset C Controller setting utility
1003H Output mode at STOP to RUN C Controller setting utility
1007H Points occupied by empty slot C Controller setting utility
100AH Intelligent function module settings (Interrupt event settings) C Controller setting utility
100CH Module synchronization C Controller setting utility
1016H Built-in Ethernet port open setting C Controller setting utility
2000H Device setting Number of device points C Controller setting utility