2
SYSTEM CONFIGURATION
2.1 System Configuration
2.1.5 Connecting a GOT in a bus topology
2 - 15
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK
MODULES
6
PREPARATORY
PROCEDURES AND
SETTING
7
I/O NUMBER
ASSIGNMENT
8
MEMORIES AND FILES
• The following system alarm may occur in the GOT at start-up, depending on the
system configuration and GOT settings.
"402 A communication timeout occurred. Check the communication path or
module."
To avoid the occurrence of the above system alarm, set the GOT title display time
to be sufficiently longer than the C Controller module start-up time.
For how to set the GOT title display time, refer to the following.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
(4) System configuration overview
Figure 2.12 Example of a system configuration using GOT
C Controller module
Q35B (exclusive 5 slots)
Q68B (exclusive 8 slots)
Q65B (exclusive 5 slots)
00 to 0F
10 to 1F
20 to 2F
30 to 3F
40 to 4F
50 to 5F
60 to 6F
70 to 7F
80 to 8F
90 to 9F
A0 to AF
B0 to BF
C0 to CF
D0 to DF
E0 to EF
F0 to FF
100 to 10F
110 to 11F
CPU 0 1 2 3 4
5 6 7 8 9 101112
13 14 15 16 17
Q series
power supply
module
Number of
Ext.Bases: 3
Slot No.: 0
The extension base image for GOT connection by C Controller module side
120 to 12F
130 to 13F
140 to 14F
150 to 15F
160 to 16F
18 19 20 21 22 23 24 25 26 27
1) 2) 3) 4) 5)
1) 2) 3) 4) 5)
Number of
Ext.Bases: 3
Slot No.: 1
Number of
Ext.Bases: 3
Slot No.: 2
Number of
Ext.Bases: 3
Slot No.: 3
Number of
Ext.Bases: 3
Slot No.: 4
Setting
by GOT
Sets data as empty in "I/O assignment setting" of
C Controller setting utility.
Slot No.
I/O No.
GOT (extension base number: 3)
16 points exclusive 10 slots
Main base unit A 16-point module is mounted on each slot
Extension base unit A 16-point module is mounted on each slot
To Next Page
Loading...
