Moog MSD Servo Drive Series

11.4Errordisplay
There are a number of ways of displaying an error message. An error message is
indicated on the display of the servo drive (display D1/D2) or via the Moog
DRIVEADMINISTRATOR. It provides a user-friendly readout in the "Device status"
window.
11.4.1Servodrivedisplay
The display on the servo drive shows the various device states and possible error
messages. Two 7-segment displays are available for this purpose. To display an
error number and an error, "ER" for Error flashes, then the error number, and then
the number of the error location.
Example: ER ►16 ►01
Display
readout
Function
Attention–errormessage
Errorsmarkedwithadotonthedisplay(D1/D2)canonlybe
resetwhenthecauseofthefaulthasbeeneliminated.
Maximumspeedexceeded
Table 11.5: Servo drive error display
MOOG
ID
No.: CB40859-001 Date: 02/2018
MSD Servo Drive- Device Help
265
11 Alarm & warnings
Display
readout
Function
Speedtrackingerrorabovethresholdvalue
Table 11.5: Servo drive error display (continue)