Omron F3SG-SRB Series - Page 22

xx
Introduction
F3SG-SR
User’s Manual
2-21. Response Time Adjustment 112
2-21-1.Overview 112
2-21-2.Factory Default Setting 112
2-21-3.Setting with Intelligent Tap 112
2-21-4.Setting with SD Manager 3 112
2-22. Area Beam Indicator (ABI) 113
2-22-1.Overview 113
2-22-2.Factory Default Setting 114
2-22-3.Setting Change using Intelligent Tap 114
2-22-4.Setting Change using SD Manager 3 114
2-23. Designated Beam Output 116
2-23-1.Overview 116
2-23-2.Factory Default Setting 116
2-23-3.Setting with Intelligent Tap 116
2-23-4.Setting with SD Manager 3 117
2-24. Stable Light Threshold Adjustment 118
2-24-1.Overview 118
2-24-2.Factory Default Setting 118
2-24-3.Setting Change using Intelligent Tap 118
2-24-4.Setting Change using SD Manager 3 118
2-25. Incident Light/Ambient Light 119
2-25-1.Incident Light Level Information 119
2-25-1-1. Overview 119
2-25-1-2. Setting with SD Manager 3 119
2-25-2.Ambient Light Level Information 119
2-25-2-1. Overview 119
2-25-2-2. Setting with SD Manager 3 119
2-26. Maintenance Information 120
2-26-1.Overview 120
2-26-2.Error Log 120
2-26-3.Warning Log 120
2-26-4.Power-ON Time 121
2-26-5.Load Switching Frequency 121
2-26-6.Muting Statistics Information 122
2-26-7.Intelligent Tap Log 122
2-27. Operating Status Monitoring 123
2-27-1.Overview 123
2-27-2.Readout Information 123
2-28. Instantaneous Block Detection 124
2-28-1.Overview 124
2-28-2.Factory Default Setting 124
2-28-3.Setting Change using Intelligent Tap 124