Omron F3SG-SRB Series - Mounting with Adjustable Top;Bottom Brackets (F3 SJ, F3 SN Adapter) (F39-LSGTB-SJ); And Side-Mount Brackets (Intermediate Brackets) (F39-LSGF)

280
Chapter5 Mounting
F3SG-SR
User’s Manual
Wiring and Installation
5. Securely tighten the Alignment Screws to fix the Adjustable Side-Mount Bracket to the sensor housing.
The recommended torque to tighten the Alignment Screws is 3.0 N•m. (Fig. 6)
Tightening screws with a torque that considerably exceeds the recommended torque may cause failure.
5-3-4-3. Mounting with Adjustable Top/Bottom Brackets (F3SJ, F3SN
Adapter) (F39-LSGTB-SJ) and Side-Mount Brackets (Intermediate
Brackets) (F39-LSGF)
The mounting method of the Adjustable Top/Bottom Bracket (F3SG-RA/RE Adapter) (F39-LSGTB-RE) or the Adjustable
Top/Bottom Bracket (MS4800, F3SR Adapter) (F39-LSGTB-MS) are the same as that of the Adjustable Top/Bottom
Bracket (F3SJ, F3SN Adapter) (F39-LSGTBSJ).
1. Loosen the Alignment Screws (hexagon socket head cap screw (M4×7)) of the Top/Bottom Bracket (3)
and change the angle of the Top/Bottom Bracket (3) according to its mounting direction. Then loosen the
Mounting Screws (low head hexagon socket head cap screw (M4×7)) of Top/Bottom Bracket (2). (Fig. 1)
AlignmentScrew
MountingScrew
MountingScrew
AlignmentScrew
MountingScrew
AlignmentScrew
Securely
tighten
Securely
tighten
Fig. 6
1. Loosen
2. Adjust angle
3. Loosen
2. Adjust angle
1. Loosen
Fig. 1
Top/Bottom Brac
k
Top/Bottom Bracket (2)
Top/Bottom Bracket (3)
<Side mounting><Backside mounting>
Alignment Screw
(hexagon socket head
cap screw (M4×7))
Alignment Screw
(hexagon socket head
cap screw (M4×7))
Top/Bottom Bracket (3)
Top/Bottom Bracket (1)
Top/Bottom Bracket (2)
Mounting Screw
(hexagon socket head cap screw (M4×7))
Top/Bottom Bracket (3)
Top/Bottom Bracket (2)