287
F3SG-SR
User’s Manual
Chapter5 Mounting
Wiring and Installation
E
6.
Securely tighten screws to fix the Top/Bottom Bracket to the mounting position of the wall surface. (Fig.7)
Screws to mount the brackets to the wall are not included.
7. Power the emitter and receiver on to perform beam alignment.
Move the emitter and receiver from side to side (Fig. 8) to check the state of the beams
For more information on the beam alignment procedure, refer to 5-3-5. Beam Alignment Procedure.
Fig. 7
M8 M8
M5/M6 M5/M6
Using one M8 screw
<Backside mounting> <Side mounting> <Backside mounting> <Side mounting>
Using two M5 or M6 screws
Fig. 8
To Next Page
Loading...
