Appendix Programming Information
1301
No
.
Name Default Values
18 Index register hold area start address 0 0–14
14 Step ladder hold/non-hold Non-hold Hold/Non-hold
15
1
)
File register bank 1 hold area start address 0 0–32765
19
1
)
File register bank 2 hold area start address 0 0–32765
1)
For FP2SH only
Act on Error
No. Name Default Values
4 Battery error indication Enable Disable: When a battery error occurs, a self-diagnostic error
is not issued and the ERROR LED will not flash.
Enable: When a battery error occurs, a self-diagnostic error
is issued and the ERROR will LED flash.
4 Internal relay (R)
4 Link relay (L)
4 Timer/counter (T, C, SV, EV)
4 Data register (DT)
4 Link register (LD)
4 File register (FL)
4 Index register (I)
4
1)
Error alarm relay (E)
Clear Clear/Don't clear
4 DF-, P-function leading/falling
edge detection
Holds result Holds result/disregards result
4
1)
Timer instruction operation Synchronou
s
Synchronous/Asynchronous
4 Index modifier check On On/Off
20 Duplicate output Enable Fixed
21 Output unit fuse blow
22 Intelligent unit error
23 I/O verification error
24
1)
Watchdog timer time-out by
operation jam
26 Operation error
27 Remote I/O slave link error
28 I/O error in the remote I/O slave
station
Stop Stop/Continue
1)
FP2SH/FP10SH only
Time-Out
No. Name Default Values
29
1)
Operation time for the
peripheral tasks
240.0
s 0.0–52428.0s
To Next Page
Loading...
