Panasonic FP Series User Manual

Conversion instructions
646
Part III FP Instructions
Example
In this example, the same POU header is used for all programming languages. For an example
using IL (instruction list), please refer to the online help.
POU header
All input and output variables used for programming this function have been declared in the POU
header.
Body
When the variable Enable is set to TRUE, the function is executed. The number of bytes to be
converted is entered directly at the contact pin for s2. This programming example is based on the
example for the conversion of a negative number outlined above.
LD
ST
When programming with structured text, enter the following:
IF Enable THEN
F78_DA2BIN( s1_Start:= ASCII_input[0] ,
s2_Number:= 10 ,
d=> DINT_output );
END_IF;

Panasonic FP Series Specifications

General

Mounting	DIN rail
Type	PLC
Communication Interface	RS-232, RS-485, Ethernet (depending on model)
Input Voltage	100-240V AC or 24V DC (depending on model)
Output Type	Relay, Transistor
I/O Points	Varies by model
Operating Temperature	0°C to 55°C
Dimensions	Varies by model
Weight	Varies by model