Registering Addresses and Users for Scanner Functions
216
7
Changing NCP settings
To change NCP settings:
A Select the type of connection.
B Press [Change] of path name.
C Enter the name of the path on which the folder is located, and then press
[OK].
D Press [Connection Test] to make sure the path is correctly set up.
E When you have made the necessary changes to the information, press [Set].
F Press [Close].
Note
❒ To specify a folder, enter its path directly or select it using Browser Net-
work.
Reference
p.214 “To locate the folder manually”
p.214 “Using Browse Network to locate the folder”
To change the protocol
A Press [SMB], or [FTP].
B A confirmation message appears. Press [Yes].
Changing the protocol will clear all settings made under the previous protocol.
C Enter each item again.
Reference
p.200 “Registering a Folder”
p.207 “Registering a Folder”
To Next Page
Loading...