When a Message Appears
23
2
❖ Connect Copy
Message Cause Solution
Cannot connect to
the sub-machine.
Check the status of
the sub-machine.
•The L indicator is lit.
• The hard disk of the
sub-machine is mal-
functioning.
Press [Exit] on the main machine and
follow the instructions on the display.
Cannot print from
the sub-machine.
Check the status of
the sub-machine.
A paper misfeed has oc-
curred on the sub-ma-
chine, or toner or other
supplies need to be re-
plenished.
Follow the instructions displayed. For
details, see p.87 “Adding Toner”, p.93
“Removing Jammed Paper”, p.106 “Re-
moving Jammed Staples”.
If the sub-machine's display indicates
that a cover is open, follow the instruc-
tions displayed.
Cannot print from
the sub-machine.
Check the status of
the sub-machine.
The sub-machine's User
Tools menu is open.
Press the {User Tools} key to close the
User Tools menu.
Sub-machine is in
Interrupt mode.
The sub-machine is in In-
terrupt mode.
Press the {Interrupt} key on the sub-ma-
chine to cancel Interrupt mode.
Sub-machine does
not have the same
paper setting(s).
Paper type or tray set-
tings on the two ma-
chines do not match.
Make the same settings on both ma-
chines.
The Cover Sheet
setting(s) of the
sub-machine is
different from
the main machine
.
Cover settings on the two
machines do not match.
Make the same settings on both ma-
chines.
The Slip Sheet
setting(s) of the
sub-machine is
different from
the main machine.
Slip Sheet settings on the
two machines do not
match.
Make the same settings on both ma-
chines.
The Designation
Sheet setting(s)
of sub-machine is
different from
main machine.
Designation Sheet set-
tings on the two ma-
chines do not match.
Make the same settings on both ma-
chines.
Sub-machine paper
settings must be
the same to use
this tray.
Paper tray settings on the
two machines do not
match.
Make the same settings on both ma-
chines.
No stamp data in
the sub-machine.
Stamp data on the sub-ma-
chine has been deleted.
Reprogram the stamp on the sub-ma-
chine.
To Next Page