Using Connect Copy
157
3
G Collect your copies from both the main and sub machines.
Note
❒ If you cancel Connect Copy mode, press [Connect Copy], which is highlight-
ed on the main machine.
❒ The number of copies might differ on the main and sub machines.
❒ Both machines may not finish copying at the same time.
❒ When using the Sort/Staple function, copying is divided between the two
machines by the number of sets. If a paper misfeed occurs when processing
a set of copes, it is not possible for the other machine to take over the re-
mainder of that particular set.
❒ To interrupt ADF scanning, press the {Stop} key on the main machine, and
then select [Stop] in response to the message that appears.
❒ To stop copying, press the {Stop} key on the main machine, and then select
[Stop] in response to the message that appears.
❒ If the memory required to store originals exceeds the memory limit, an er-
ror message appears. For details, see “When You Cannot Make Copies As
Wanted”, Troubleshooting.
Reference
p.21 “Batch mode”
“When the Authentication Screen is Displayed”, About this Machine
“Administrator Tools”, General Settings Guide
“When You Cannot Make Copies As Wanted”, Troubleshooting
To Next Page