Rohde & Schwarz R&S FSL3 - Page 1060

R&S FSL SENSe Subsystem (Analog Demodulation, K7)
1300.2519.12 6.301 E-11
[
SENSe:]ADEMod[:STATe]
This command activates the analog demodulator of the instrument. The instrument will be set to
zero span at the current center frequency.
Parameter
ON | OFF
Example
ADEM ON
Switches the analog demodulator on.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
ADEMOD
[SENSe:]ADEMod:AF:CENTer
This command sets the center frequency for AF spectrum result display.
Parameter
<numeric_value>
Example
ADEM ON
Switches on the analog demodulator
CALC:FEED 'XTIM:FM:AFSP'
Switches on AF spectrum result display of FM
ADEM:BAND 5 MHz
Sets the measurement bandwidth to 5 MHz
ADEM:AF:CENT 500kHz
Sets the AF center frequency to 500 kHz
ADEM:AF:SPAN 200kHz
Sets the AF span to 200 kHz
Characteristics
*RST value: 1.25 MHz
SCPI: device–specific
Mode
ADEMOD