Rohde & Schwarz R&S FSL3 - Sense Subsystem (EVDO, K84)

Remote Commands of the 1xEV-DO BTS Analyzer Option (K84) R&S FSL
1300.2519.12 6.656 E-11
SENSe Subsystem (EVDO, K84)
The SENSe subsystem controls the essential parameters of the analyzer. In accordance with the SCPI
standard, the keyword "SENSe" is optional for this reason, which means that it is not necessary to
include the SENSe node in command sequences.
The following subsystems is included:
• "SENSe:CDPower Subsystem (EVDO, K84)" on page 6.656
SENSe:CDPower Subsystem (EVDO, K84)
This subsystem sets the parameters for the code domain measurements mode. The numeric suffix at
SENSe<1|2> is irrelevant.
Commands of the SENSe:CDPower Subsystem
– [SENSe<1|2>:]CDPower:AVERage
– [SENSe<1|2>:]CDPower:CODE
– [SENSe<1|2>:]CDPower:ICTReshold
– [SENSe<1|2>:]CDPower:IQLength
– [SENSe<1|2>:]CDPower:CTYPe
– [SENSe<1|2>:]CDPower:ICTReshold
– [SENSe<1|2>:]CDPower:IQLength
– [SENSe<1|2>:]CDPower:LEVel:ADJust
– [SENSe<1|2>:]CDPower:MAPPing
– [SENSe<1|2>:]CDPower:MMODe
– [SENSe<1|2>:]CDPower:NORMalize
– [SENSe<1|2>:]CDPower:OVERview
– [SENSe<1|2>:]CDPower:PNOFfset
– [SENSe<1|2>:]CDPower:QINVert
– [SENSe<1|2>:]CDPower:SBANd
– [SENSe<1|2>:]CDPower:SLOT
– [SENSe<1|2>:]CDPower:TPMeas
[SENSe<1|2>:]CDPower:AVERage
This command can be precisely enabled by means of ON when the Code Domain Power
analysis is active (refer to CALCulate<1|2>:FEED). If averaging is active, the CDP is calculated
over all slots and displayed as called for by the 1xEV–DO Standard.
Parameter
ON | OFF
Example
CDP:AVER ON
Activate averaging CDP relative over all slots and display on screen A.