Rohde & Schwarz R&S FSL3 - Page 1419

Remote Commands of the 1xEV-DO BTS Analyzer Option (K84) R&S FSL
1300.2519.12 6.660 E-11
Example
CDP:MAPP Q
Selects the Q branch.
Characteristics
RST value: I
SCPI: device-specific
Mode
EVDO
[SENSe<1|2>:]CDPower:MMODe
This command defines the mapping mode. With AUTO, internal working takes place in
"Complex" mapping mode for the DATA channel type and "I or Q" for the PILOT, MAC and
PREAMBLE channel types. With this command, each mapping mode can be determined
personally for all channel types, or it is possible to return to AUTO.
Parameter
AUTO | IOQ | COMPlex
Example
CDP:MMODe COMP
The pilot channel type is analyzed complex
Characteristics
RST value: AUTO
SCPI: device-specific
Mode
EVDO
[SENSe<1|2>:]CDPower:NORMalize
This command activates or deactivates the elimination of the IQ offset from the signal.
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
ON | OFF
Example
CDPower:NORMalize ON
Activates the elimination of the I/Q offset.
Characteristics
RST value: OFF
SCPI: device-specific
Mode
EVDO