R&S FSL INITiate Subsystem (SPECM, K14)
1300.2519.12 6.407 E-11
INITiate Subsystem (SPECM, K14)
The INITiate subsystem is used to control the init–measurement function.
INITiate<1|2>:CONTinuous
This command starts a continuous sweep measurement or stops it and switches to single
sweep mode.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON Starts a continuous sweep measurement.
OFF Stops the continuous sweep measurement and switches to single sweep
mode.
Example
INIT:CONT OFF
Stops the continuous sweep measurement and switches to single sweep mode.
Characteristics
*RST value: ON
SCPI: conform
Mode
SPECM
To Next Page
Loading...
