Rohde & Schwarz R&S FSL3 - Status Subsystem (Noise Figure, K30)

STATus Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.558 E-11
STATus Subsystem (Noise Figure, K30)
The STATus subsystem contains the commands for the status reporting system (See Section ""). *RST
does not influence the status registers.
Commands of the STATus subsystem
– STATus:QUEStionable:CORRection[:EVENt]?
– STATus:QUEStionable:CORRection:CONDition?
– STATus:QUEStionable:CORRection:ENABle
– STATus:QUEStionable:CORRection:NTRansition
– STATus:QUEStionable:CORRection:PTRansition
– STATus:QUEStionable:FREQuency[:EVENt]?
– STATus:QUEStionable:FREQuency:CONDition?
– STATus:QUEStionable:FREQuency:ENABle
– STATus:QUEStionable:FREQuency:NTRansition
– STATus:QUEStionable:FREQuency:PTRansition
– STATus:QUEStionable:LIMit<1|2> [:EVENt]?
– STATus:QUEStionable:LIMit<1|2>:CONDition?
– STATus:QUEStionable:LIMit<1|2>:ENABle
– STATus:QUEStionable:LIMit<1|2>:NTRansition
– STATus:QUEStionable:LIMit<1|2>:PTRansition
STATus:QUEStionable:CORRection[:EVENt]?
This command queries the contents of the EVENt section of the
STATus:QUEStionable:CORRection register. Readout deletes the contents of the EVENt
section.
Example
STAT:QUES:CORR?
Characteristics
*RST value: –
SCPI: conform
Mode
NF