R&S FSL TRACe Subsystem
1300.2519.12 6.263 E-11
TRACe Subsystem
The TRACe subsystem controls access to the instruments internal trace memory.
The following subsystem is included:
• "TRACe:IQ Subsystem" on page 6.265
Commands of the TRACe Subsystem
– TRACe<1|2>[:DATA]
– TRACe:COPY
TRACe<1|2>[:DATA]
This command transfers trace data from the control computer to the instrument, the query reads
trace data out of the instrument. The transfer of trace data from the control computer to the
instrument takes place by indicating the trace name and then the data to be transferred.
For details on saving and recalling data refer to chapter 5 "Remote Control – Basics", section
"MMEMory Subsystem".
Parameter
TRACE1 | TRACE2 | TRACE3 | TRACE4 | TRACE5 | TRACE6 | LIST | SPURious,<block> |
<numeric_value>
TRACE1, ... , TRACE6 trace memory to be read out
<block> or <numeric_value> data to be transferred
query only:
LIST lists all results of the Spectrum Emission Mask and Spurious
Emissions measurement
SPURious lists all peaks of the Spurious Emissions measurement
Return values for trace data
501 results are returned. The returned values are scaled in the current level unit.
FORMat REAL,32 is used as format for binary transmission, and FORMat ASCii for ASCII
transmission. For details on formats refer to "Formats for returned values: ASCII format and
binary format" on page 6.300.
Note: With the auto peak detector, only positive peak values can be read out.
To Next Page
Loading...
