Remote Commands of the CDMA2000 BTS Analyzer Option (K82) R&S FSL
1300.2519.12 6.624 E-11
TRACe Subsystem (CDMA, K82)
The TRACe subsystem controls access to the instruments internal trace memory.
Commands of the TRACe Subsystem
– TRACe<1|2>[:DATA]
TRACe<1|2>[:DATA]
This command transfers trace data from the controller to the R&S FSL, the query command
reads trace data from the R&S FSL.The numeric suffix at TRACe<1|2> is irrelevant.
For details on reading trace data for other than code domain measurements refer to
TRACe<1|2>[:DATA].
Parameter
TRACE1 |
TRACE2
Reads out the trace data of measurement window 1 or 2.
CTABle For the Channel Table result display, reads out the maximum values
of the timing/phase offset between every assigned channel and the
pilot channel (see also [SENSe<1|2>:]CDPower:TPMeas
command).
Return values
The measurement results are explained separately for each measurement and illustrated by a
short example:
– Code Domain Power on page 6.625
– Code Domain Error Power on page 6.626
– Channel Table on page 6.627
– Result Summary on page 6.629
– Power vs PCG on page 6.630
– Peak Code Domain Error on page 6.630
– Composite EVM on page 6.630
– EVM vs Symbol on page 6.631
– Power vs Symbol on page 6.631
– Channel Constellation on page 6.631
– Composite Constellation on page 6.631
– Channel Bitstream on page 6.632
Characteristics
RST value: -
SCPI: conform
Mode
CDMA
To Next Page
Loading...
