Rohde & Schwarz R&S FSL3 - 3 GPP Base Station Measurements (Option K72)

R&S FSL 3GPP Base Station Measurements (Option K72)
1300.2519.12 4.271 E-11
3GPP Base Station Measurements (Option K72)
The R&S FSL equipped with the 3GPP Base Station Measurements option performs code domain
power measurements on downlink signals according to the 3GPP standard (Third Generation
Partnership Project, FDD mode). Signals that meet the conditions for channel configuration of 3GPP
standard test models 1 to 5 can be measured, including HSDPA and HSUPA signals (test model 5). In
addition to the code domain power measurements specified by the 3GPP standard, the 3GPP Base
Station Measurements option offers measurements with predefined settings in the frequency domain,
e.g. power measurements.
This option is available from firmware version 1.60.
To open the settings menu
 If the 3G FDD BTS mode is not the active measurement mode, press the MODE key and activate
the 3G FDD BTS option.
 If the 3G FDD BTS mode is already active, press the MENU key.
The settings menu is displayed. .
Menu and softkey description
– "Softkeys of the settings menu (3G FDD BTS mode)" on page 4.275
– "Softkeys of the frequency menu (3G FDD BTS mode)" on page 4.279
– "Softkeys of the amplitude menu (3G FDD BTS mode)" on page 4.280
– "Softkeys of the trigger menu (3G FDD BTS mode)" on page 4.281
– "Softkeys of the marker menu (3G FDD BTS mode)" on page 4.281
– "Softkeys of the marker–> menu (3G FDD BTS mode)" on page 4.282
– "Softkeys of the measurement menu (3G FDD BTS mode)" on page 4.283
The span, bandwidth, and lines menus are not available in the 3G FDD BTS mode. All other menus are
provided as described for the base unit. For details refer to the corresponding menu descriptions.
To display help to a softkey, press the HELP key and then the softkey for which you want to display
help. To close the help window, press the ESC key. For further information refer to section "How to use
the Help System".
Further information
– "Short list of abbreviations" on page 4.273
– "Channels of the Code Domain Channel Table and their usage" on page 4.273
– "Marker values" on page 4.274
Measurements and result displays
The 3GPP Base Station Measurements option provides the following test measurement types and
result displays:
• code domain power measurements
– Code Domain Power Diagram (see Code Dom Power Diagram softkey)
– Code Domain Channel Table (see Code Dom Channel Table softkey)
– Code Domain Result Summary (see Code Dom Result Summary softkey)