Rohde & Schwarz R&S FSL3 - CDMA2000 (K82) and 1 Xev-DO (K84) BTS Analyzer - Status Reporting System; Status:questionable:sync Register

CDMA2000 (K82) and 1xEV-DO (K84) BTS Analyzer – Status Reporting SystemR&S FSL
1300.2519.12 5.40 E-11
CDMA2000 (K82) and 1xEV-DO (K84) BTS Analyzer –
Status Reporting System
Additionally to the registers provided by the base system, the following register is used in the
CDMA2000 BTS Analyzer option (K82):
• STATus:QUEstionable:SYNC Register
Although this register is provided by the base system, the CDMA2000 BTS Analyzer option (K82)
uses different bits and definitions.
Detailed information on the status registers of the base system is given in section Status Reporting
System. In this section, only the new and altered status registers / bits for the CDMA2000 BTS Analyzer
option (K82) are described.
This option is available from firmware version 1.90.
STATus:QUEstionable:SYNC Register
This register contains information on the error situation in the code domain analysis of the CDMA2000
BTS Analyzer option.
The bits can be queried with commands
STATus:QUEStionable:SYNC:CONDition?
and
STATus:QUEStionable:SYNC[:EVENt]?
.
Bit No Meaning
0 This bit is not used.
1
K82 Frame Sync failed
This bit is set when synchronization is not possible within the application.
Possible reasons:
• Incorrectly set frequency
• Incorrectly set level
• Incorrectly set PN Offset
• Incorrectly set values for Swap IQ
• Invalid signal at input
2 to 14 These bits are not used.
15 This bit is always 0.