Rohde & Schwarz R&S FSL3 - Trigger Subsystem (WLAN, K91; K91 N)

R&S FSL TRIGger Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.751 E-11
TRIGger Subsystem (WLAN, K91 / K91n)
The trigger subsystem is used to synchronize device action(s) with events.
Commands of the TRIGger Subsystem
– TRIGger[:SEQuence]:HOLDoff
– TRIGger[:SEQuence]:MODE
– TRIGger[:SEQuence]:LEVel:POWer
– TRIGger[:SEQuence]:LEVel:POWer:AUTO
TRIGger[:SEQuence]:HOLDoff
This command defines the length of the trigger delay. A negative delay time (pretrigger) can be
set.
Parameter
<numeric_value>
Example
TRIG:HOLD 500us
Configures to use a holdoff period of 500 U s after the trigger condition has been met.
Characteristics
*RST value: –10 µs
SCPI: Conform
Mode
WLAN
TRIGger[:SEQuence]:MODE
This command configures how triggering is to be performed.
Parameter
IMMediate automatically triggers the next measurement at the end of the previous
measurement. This corresponds to the FREE RUN setting.
EXTernal the next measurement is triggered by the signal at the external trigger input
e.g. a gated trigger
POWer triggering of the measurement via signals which are the measurement
channel.
Example
TRIG:MODE IMM
AUTO triggering will occur for the next measurement at the specified video percentage value.
Characteristics
*RST value: IMMediate
SCPI: device–specific
Mode
WLAN