R&S FSL Noise Figure Measurements (K30) – Status Reporting System
1300.2519.12 5.37 E-11
Noise Figure Measurements (K30) – Status Reporting
System
Additionally to the registers provided by the base system, the following registers are used or modified in
the Noise Figure Measurements option (K30):
• STATus:OPERation Register
Although this register is provided by the base system, the Noise Figure Measurements option
makes use of bits not used within the base system.
• STATus:QUEStionable Register
Although this register is provided by the base system, the Noise Figure Measurements option uses
different bits and definitions.
• STATus:QUEStionable:CORRection Register
This register is provided by the R&S FS–K30 option.
The following registers are provided by the base system and are not available from the Noise Figure
Measurements option (K30) command tree:
• STATus:QUEStionable:ACPLimit Register
• STATus:QUEStionable:LIMit Register
• STATus:QUEStionable:LMARgin Register
• STATus:QUEStionable:POWer Register
Detailed information on the status registers of the base system is given in section Status Reporting
System. In this section, only the new and altered status registers / bits for the Noise Figure
Measurements option (K30) are described.
This option is available from firmware version 1.50.
STATus:OPERation Register
Additionally to the bits assigned by the base system (for details refer to STATus:OPERation Register),
the bits no. 4 and 7 are defined:
Bit No Meaning
4
MEASuring
A '1' in this bit position indicates that a measurement is in progress.
7
CORRecting
Indicates that a user calibration is in progress.
To Next Page
Loading...
