SENSe Subsystem (WCDMA, K72) R&S FSL
1300.2519.12 6.582 E-11
SENSe Subsystem (WCDMA, K72)
The SENSe subsystem is organized in several subsystems. The commands of these subsystems
directly control device–specific settings, they do not refer to the signal characteristics of the
measurement signal.
The SENSe subsystem controls the essential parameters of the analyzer. In accordance with the SCPI
standard, the keyword "SENSe" is optional for this reason, which means that it is not necessary to
include the SENSe node in command sequences.
The following subsystems are included:
• "SENSe:AVERage Subsystem (WCDMA, K72)" on page 6.582
• "SENSe:CDPower Subsystem (WCDMA, K72)" on page 6.583
• "SENSe:FREQuency Subsystem (WCDMA, K72)" on page 6.590
• "SENSe:SWEep Subsystem (WCDMA, K72)" on page 6.590
SENSe:AVERage Subsystem (WCDMA, K72)
The SENSe:AVERage subsystem calculates the average of the acquired data. A new test result is
obtained from several successive measurements.
Commands of the SENSe:AVERage Subsystem
– [SENSe<1|2>:]AVERage:COUNt
[SENSe<1|2>:]AVERage:COUNt
For details refer to "[SENSe<1|2>:]AVERage:COUNt" on page 6.173.
To Next Page
Loading...
