Power Meter (Option K9) R&S FSL
1300.2519.12 4.186 E-11
Power Meter (Option K9)
For precise power measurement a power sensor is connected to the instrument via the front panel
(USB connector) or the rear panel (power sensor, option R&S FSL–B5). The Power Sensor Support
firmware option provides the power measurement functions for this test setup (see Fig. 4-21: Power
sensor support – standard test setup). Both manual operation and remote control are supported. The
functions of this firmware option are described in this section. For details on the connectors and
compatible power sensors refer to the Quick Start Guide, chapter 1, "Front and Rear Panel".
Fig. 4-21: Power sensor support – standard test setup
To open the power meter menu
1. Press the MENU key.
2. Press the Power Meter softkey.
The power meter menu is displayed.
Menu and softkey description
– "Softkeys of the power meter menu" on page 4.187
To display help to a softkey, press the HELP key and then the softkey for which you want to display
help. To close the help window, press the ESC key. For further information refer to section "How to use
the Help System".
Tasks
– To zero the power meter
– To use the power meter
To Next Page
Loading...
