Cable TV Measurements (Option K20) R&S FSL
1300.2519.12 2.46 E-11
Cable TV Measurements (Option K20)
This section describes measurement examples for the Cable TV Measurements option (K20). and is
divided into the following topics:
Analog TV Basics
gives an introduction into the fundamentals of analog modulated TV signals.
Analog TV Measurement Examples
describes the test setup, settings for analog TV measurements and gives examples for the different
measurement type.
Digital TV Basics
gives an introduction into the fundamentals of digital modulated TV signals.
Digital TV Measurement Examples
gives an introduction into the fundamentals of digital modulated TV signals.
Channel Tables and Modulation Standards
explains the use of channel tables and modulation standards.
Performing a Measurement without a Channel Table
shows how to perform a measurement without using a channel table.
Performing a Measurement Using a Channel Table
gives an example how to perform a measurement using a channel table.
For further information on measurement examples refer also to the Quick Start Guide, chapter 5 "Basic
Measurement Examples".
This option is available from firmware version 1.30.
To Next Page
Loading...
