R&S FSL Initializing the Configuration – PRESET Key
1300.2519.12 4.3 E-11
Initializing the Configuration – PRESET Key
The PRESET key resets the instrument to the default setting and therefore provides a defined initial
state as a known starting point for measurements
Note: If the LOCAL LOCKOUT function is active in the remote control mode, the PRESET key is
disabled.
Further information
– "Initial configuration" on page 4.4
Task
– To preset the instrument
To preset the instrument
1. Define the data set for the preset:
– To retrieve the originally provided settings file (see Initial configuration), in the file menu,
deactivate the Startup Recall softkey.
– To retrieve a customized settings file, in the file menu, activate the Startup Recall softkey,
press the Startup Recall Setup softkey, and select the corresponding file.
For details refer to section "Saving and Recalling Settings Files – FILE Key".
2. Press the PRESET key to trigger a preset.
Remote: *RST or SYSTem:PRESet (for details refer to chapter "Remote Control – Commands",
section "Common Commands" or section "SYSTem Subsystem").
Note: In order to save the current settings after reboot of the instrument, create a shutdown file by
switching the analyzer in the standby mode (press the On/Off key on the FRONT panel and
wait until the yellow LED is ON). With the battery pack option, use a USB keyboard and
terminate the analyzer firmware with ALT+F4 to create the shutdown file.
To Next Page
Loading...
