Rohde & Schwarz R&S FSL3 - Using Limit Lines and Display Lines - LINES Key

Using Limit Lines and Display Lines – LINES Key R&S FSL
1300.2519.12 4.118 E-11
Using Limit Lines and Display Lines – LINES Key
The LINES key is used to configure limit and display lines.
To open the lines menu
 Press the LINES key.
The lines menu and the Select Limit Line dialog box are displayed. For details on the Select Limit
Line dialog box refer to "To select a limit line" on page 4.119.
Menu and softkey description
– "Softkeys of the lines menu" on page 4.123
To display help to a softkey, press the HELP key and then the softkey for which you want to display
help. To close the help window, press the ESC key. For further information refer to section "How to use
the Help System".
Further information
– "Display Lines" on page 4.122
– "Limit Lines" on page 4.123
Task
– To work with display lines
– To select a limit line
– To create a new limit line
– To edit an existing limit line
– To create a new limit line based upon an existing limit line
– To activate/deactivate a limit line