WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 2.144 E-11
In the Link Mode field, select the link mode of the bursts to be analyzed.
In the Demodulator field, select the used modulation scheme.
Performing the level detection
1. Connect the DUT to the RF input of the R&S FSL.
2. Start the level detection measurement by pressing the SWEEP hardkey and then the Auto Level
softkey.
During the level detection measurement the status message Running is displayed in the status bar
at the bottom of the screen.
After successful level detection, the status message Measurement Complete is displayed, the
signal level field for the selected input displays the detected signal level and the Magnitude Capture
Buffer (screen A) displays the zero span trace obtained during the measurement sequence.
Note: An automatic level detection can be performed in two ways:
Once by pressing the Auto Level softkey in the sweep menu.
At the start of each measurement sweep by activating the Auto Lev option in the General
settings dialog box under Level Settings.
Performing the main measurement
1. Select single sweep measurements by pressing the SWEEP hardkey and then the Run softkey to
select Single.
2. Start the measurement by pressing the RUN hardkey.
During the measurement, the status message Running is displayed.
Measurement results are updated once the measurement has completed. The results are displayed
in graphical form. The display can be toggled to a tabular list of measurement points by pressing
the Display Graph/List softkey (in the WiMAX/WiBro menu or trace menu).
To Next Page
Loading...
