Rohde & Schwarz R&S FSL3 - Sense Subsystem (WLAN, K91; K91 N)

SENSe Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.726 E-11
SENSe Subsystem (WLAN, K91 / K91n)
The SENSe command is used to set and get the values of parameters in the remote instrument.
The get variant of the SENSe command differs from set in that it takes no parameter values
(unless otherwise stated) but is followed by the character '?' and will return the parameter's
value in the same format as it is set.
Commands of the SENSe Subsystem
– [SENSe:]BURSt:COUNt
– [SENSe:]BURSt:COUNt:STATe
– [SENSe:]DEMod:BANalyze:DURation:EQUal
– [SENSe:]DEMod:BANalyze:DURation:MAX
– [SENSe:]DEMod:BANalyze:DURation:MIN
– [SENSe:]DEMod:CESTimation
– [SENSe:]DEMod:FILTer:CATalog?
– [SENSe:]DEMod:FILTer:MODulation
– [SENSe:]DEMod:FORMat[:BCONtent]:AUTo
– [SENSe:]DEMod:FORMat:BANalyze
– [SENSe:]DEMod:FORMat:BANalyze:BTYPe
– [SENSe:]DEMod:FORMat:BANalyze:DBYTes:EQUal
– [SENSe:]DEMod:FORMat:BANalyze:DBYTes:MAX
– [SENSe:]DEMod:FORMat:BANalyze:DBYTes:MIN
– [SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal
– [SENSe:]DEMod:FORMat:BANalyze:SYMBols:MAX
– [SENSe:]DEMod:FORMat:BANalyze:SYMBols:MIN
– [SENSe:]DEMod:FORMat:BTRate
– [SENSe:]DEMod:FORMat:SIGSymbol
– [SENSe:]FREQuency:CENTer
– [SENSe:]POWer:ACHannel:MODE
– [SENSe:]SWAPiq
– [SENSe:]SWEep:COUNt
– [SENSe:]SWEep:EGATe
– [SENSe:]SWEep:EGATe:HOLDoff[:TIME]
– [SENSe:]SWEep:EGATe:HOLDoff:SAMPle
– [SENSe:]SWEep:EGATe:LENGth[:TIME]
– [SENSe:]SWEep:EGATe:LENGth:SAMPle
– [SENSe:]SWEep:EGATe:LINK
– [SENSe:]SWEep:TIME
– [SENSe:]TRACking:LEVel
– [SENSe:]TRACking:PHASe