R&S FSL SENSe Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.733 E-11
[SENSe:]DEMod:FORMat:BANalyze:DBYTes:MAX
This command specifies the maximum number of data bytes required for bursts to qualify for
measurement analysis. Only bursts with the specified number of data bytes will be used in the
measurement analysis.
This value will not have any immediate effect if the
[SENSe:]DEMod:FORMat:BANalyze:DBYTes:EQUal command has been set to ON. In this
case, no range of symbols is allowed and only bursts with exactly the number of data bytes
specified by the [SENSe:]DEMod:FORMat:BANalyze:DBYTes:MIN command shall take part
in measurement analysis.
Parameter
<numeric_value>
Example
DEM:FORM:BAN:DBYTes:MAX 1300
Only bursts which contain a maximum of 1300 data bytes are analyzed.
Characteristics
*RST value: 64
SCPI: device–specific
Mode
WLAN
[SENSe:]DEMod:FORMat:BANalyze:DBYTes:MIN
This command specifies the number of data bytes required for bursts to qualify for
measurement analysis. Only bursts with the specified number of data bytes will be used in the
measurement analysis.
If the [SENSe:]DEMod:FORMat:BANalyze:DBYTes:EQUal command has been set to ON,
this command specifies the exact number of data bytes required for a burst to take part in
measurement analysis. If the [SENSe:]DEMod:FORMat:BANalyze:DBYTes:EQUal
command is set to OFF, this command specifies the minimum number of data bytes required for
a burst to take part in measurement analysis.
Parameter
<numeric_value>
Example
DEM:FORM:BAN:DBYTes:MIN 16
Only bursts which contain 16 data bytes are analyzed.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
