Rohde & Schwarz R&S FSL3 - Page 1491

SENSe Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.732 E-11
C
haracteristics
*RST value: QAM64
SCPI: device–specific
M
ode
WLAN
[SENSe:]DEMod:FORMat:BANalyze:BTYPe
This remote control command specifies the type of burst to be analyzed. Only bursts of the
specified type take part in measurement analysis.
Parameter
DIRECT IEEE 802.11a, IEEE 802.11j (10MHz), IEEE 802.11j (20MHz),
IEEE 802.11g, 802.11 OFDM Turbo – Direct Link Burst
LONG–OFDM IEEE 802.11g – Long DSSS OFDM
SHORT–OFDM IEEE 802.11g – Short DSSS OFDM
LONG IEEE 802.11b, IEEE 802.11g – Long PLCP Burst
SHORT IEEE 802.11b, IEEE 802.11g – Short PLCP Burst
MM20 IEEE 802.11n Mixed Mode 20 MHz sampling rate
GFM20 IEEE 802.11n Greenfield Mode 20 MHz sampling rate
Example
DEM:FORM:BAN:BTYPe 'DIRECT'
Only DIRECT bursts are analyzed.
Characteristics
*RST value: DIRECT
SCPI: device–specific
Mode
WLAN
[SENSe:]DEMod:FORMat:BANalyze:DBYTes:EQUal
When this command is set to ON then only bursts of equal length will take part in the
measurement analysis. The number of data bytes that a burst must have in order to take part in
measurement analysis is specified by the [SENSe:]DEMod:FORMat:BANalyze:DBYTes:MIN
command.
Parameter
ON | OFF
Example
DEM:FORM:BAN:DBYTes:EQU ON
Only bursts of equal length will take part in the measurement analysis.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
WLAN