Rohde & Schwarz R&S FSL3 - Display Subsystem (EVDO, K84)

R&S FSL DISPlay Subsystem (EVDO, K84)
1300.2519.12 6.653 E-11
DISPlay Subsystem (EVDO, K84)
The DISPLay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display.
Commands of the DISPlay Subsystem
– DISPlay:FORMat
– DISPlay[:WINDow<1|2>]:SSELect
– DISPlay[:WINDow<1|2>]:TRACe<1…6>:Y[:SCALe]:AUTO
DISPlay:FORMat
This command sets the visible screen display type to full or split screen.
Parameter
SPLit | SINGle
Example
DISP:FORM SINGle
Sets the display to full screen.
Characteristics
*RST value: SPL
SCPI: device–specific
Mode
EVDO
DISPlay[:WINDow<1|2>]:SSELect
This command selects whether screen A or screen B is active. SSELect means Screen SELect.
Example
DISP:WIND1:SSEL
Sets the screen A active.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
EVDO
DISPlay[:WINDow<1|2>]:TRACe<1…6>:Y[:SCALe]:AUTO
This command switches on or off automatic scaling of the Y–axis for the specified trace display.
Automatic scaling sets the Y–axis to automatically scale to best fit the measurement results.
The numeric suffix at WINDow<1|2> selects the measurement window. The numeric suffix at
TRACe<1...6> must be 1.
Parameter
ONCE