Remote Commands of the 1xEV-DO BTS Analyzer Option (K84) R&S FSL
1300.2519.12 6.652 E-11
C
ONFigure:CDPower[:BTS]:RFSLot
This command defines the expected signal: FULL slot or IDLE slot. Accordingly the limit lines
and the borders for calculating the mean power are set. The lower and upper limit line are called
DOPVTFL/DOPVTFU for FULL and DOPVTIL/DOPVTIU for IDLE mode. It is possible to change
these lines with the standard limit line editor.
Parameter
FULL | IDLE
Example
CONF:CDP:RFSL FULL
Use limit line for FILL slot and connect FILL slot signal
Characteristics
RST value: FULL
SCPI: device-specific
Mode
EVDO
To Next Page
Loading...
