Rohde & Schwarz R&S FSL3 - Page 1410

R&S FSL CONFigure Subsystem (EVDO, K84)
1300.2519.12 6.651 E-11
C
ONFigure:CDPower[:BTS]:PVTime:LIST[:STATe]
With this command the list evaluation which is off by default for backwards compatibility reasons
can be turned on.
Parameter
ON | OFF
Example
CONF:CDP:PVT:LIST[:STATe] ON
Characteristics
RST value: OFF
SCPI: device-specific
Mode
EVDO
CONFigure:CDPower[:BTS]:PVTime:LIST:RESult?
With this command the list evaluation results are queried in a defined order.
Example
CONF:CDP:PVT:LIST:RES
Characteristics
RST value: -
SCPI: device-specific
Mode
EVDO
CONFigure:CDPower[:BTS]:REVision
With this command whether a revision 0 (subtype 0/1) signal or a revision A (subtype 2) signal
is analyzed.
Parameter
0 | A
Example
CONF:CDP:REV 0
Revision 0 signal is analyzed
Characteristics
RST value: 0
SCPI: device-specific
Mode
EVDO