Rohde & Schwarz R&S FSL3 - Diagnostic Subsystem

DIAGnostic Subsystem R&S FSL
1300.2519.12 6.122 E-11
DIAGnostic Subsystem
The DIAGnostic subsystem contains the commands which support instrument diagnostics for
maintenance, service and repair. In accordance with the SCPI standard, all of these commands are
device-specific.
Commands of the DIAGnostic Subsystem
– DIAGnostic<1|2>:SERVice:BIOSinfo?
– DIAGnostic<1|2>:SERVice:HWINfo?
– DIAGnostic<1|2>:SERVice:INPut[:SELect]
– DIAGnostic<1|2>:SERVice:INPut:PULSed[:STATe]
– DIAGnostic<1|2>:SERVice:INPut:PULSed:PRATe
– DIAGnostic<1|2>:SERVice:NSOurce (option Additional Interfaces, B5)
– DIAGnostic<1|2>:SERVice:SFUNction
– DIAGnostic<1|2>:SERVice:STESt:RESult?
DIAGnostic<1|2>:SERVice:BIOSinfo?
This command reads the CPU board BIOS version and returns it as ASCII string.
The numeric suffixes <1|2> are irrelevant for this command.
Example
DIAG:SERV:BIOS?
Returns the BIOS version.
Return values (example)
47.11
Characteristics
*RST value: -
SCPI: device-specific
Mode
all
DIAGnostic<1|2>:SERVice:HWINfo?
This command queries the hardware information.
The numeric suffixes <1|2> are irrelevant for this command.
Return values
"<component 1>|<serial #>|<order #>|<model>|<hardware code>|<revision>|<subrevision>",
"<component 2>|<serial #>|<order #>|<model>|<hardware code>|<revision>|<subrevision>",
...
Table lines are output as string data and are separated by commas. The individual columns of
the table are separated from each other by |.