R&S FSL TRACe Subsystem (1xEV-DO, K84)
1300.2519.12 6.671 E-11
Remote Commands of the WLAN TX Measurements
Option (K91 / K91n)
This section describes the remote commands for the WLAN TX Measurements option (K91 / K91n).
The abbreviation WLAN stands for the Wireless LAN operating mode. For details on conventions used
in this chapter refer to section "Notation" on page 6.2 at the beginning of this chapter.
For further information on analyzer or basic settings commands, refer to the corresponding subsystem
in section "Remote Commands of the Base Unit" on page 6.5.
The option R&S FSL-K91 is available from firmware version 1.20.
The option R&S FSL-K91n is available from firmware version 1.90.
Subsystems of the WLAN TX Measurements option (K91 / K91n)
– "ABORt Subsystem (WLAN, K91 / K91n)" on page 6.672
– "CALCulate:BURSt Subsystem (WLAN, K91 / K91n)" on page 6.673
– "CALCulate:LIMit Subsystem (WLAN, K91 / K91n)" on page 6.674
– "CALCulate:MARKer Subsystem (WLAN, K91 / K91n)" on page 6.691
– "CONFigure Subsystem (WLAN, K91 / K91n)" on page 6.698
– "DISPlay Subsystem (WLAN, K91 / K91n)" on page 6.709
– "FETCh Subsystem (WLAN, K91 / K91n)" on page 6.712
– "FORMat Subsystem (WLAN, K91 / K91n)" on page 6.721
– "INITiate Subsystem (WLAN, K91 / K91n)" on page 6.722
– "INPut Subsystem (WLAN, K91 / K91n)" on page 6.723
– "INSTrument Subsystem (WLAN, K91 / K91n)" on page 6.724
– "MMEMory Subsystem (WLAN, K91 / K91n)" on page 6.725
– "SENSe Subsystem (WLAN, K91 / K91n)" on page 6.726
– "STATus Subsystem (WLAN, K91 / K91n)" on page 6.741
– "TRACe Subsystem (WLAN, K91 / K91n)" on page 6.745
– "TRIGger Subsystem (WLAN, K91 / K91n)" on page 6.751
– "UNIT Subsystem (WLAN, K91 / K91n)" on page 6.753
To Next Page
Loading...
