Rohde & Schwarz R&S FSL3 - Initiate Subsystem (CATV, K20)

INITiate Subsystem (CATV, K20) R&S FSL
1300.2519.12 6.480 E-11
INITiate Subsystem (CATV, K20)
The INITiate subsystem is used to control the init–measurement function.
Commands of the INITiate Subsystem
– INITiate<1|2>[:IMMediate]
– INITiate<1|2>:CONMeas
– INITiate<1|2>:CONTinuous
INITiate<1|2>[:IMMediate]
For details refer to "INITiate<1|2>[:IMMediate]" on page 6.146.
INITiate<1|2>:CONMeas
For details refer to "INITiate<1|2>:CONMeas" on page 6.147.
INITiate<1|2>:CONTinuous
For details refer to "INITiate<1|2>:CONTinuous" on page 6.147.