R&S FSL INITiate Subsystem (Noise Figure, K30)
1300.2519.12 6.545 E-11
INITiate Subsystem (Noise Figure, K30)
The INITiate subsystem configures the instrument prior to a measurement being carried out. It is
basically used to tell the instrument which measurement is to be performed and takes any necessary
step to set up the instrument for the measurement.
Commands of the INPut Subsystem
– INITiate[:IMMediate]
INITiate[:IMMediate]
This command initiates the start of a new measurement sequence. If a measurement sequence
is already in progress, the command is ignored.
This command is an event and therefore has no *RST value and no query.
Example
INIT
Starts a new measurement, if no measurement sequence is already in progress.
Characteristics
*RST value: –
SCPI: conform
Mode
NF
To Next Page
Loading...
